Study on the Effect of Laser and Plasma Treatment on the Adhesion of Composite Surface Coating

doi:10.12020/j.issn.0253-4312.2019.12.27

Paint & Coatings Industry ›› 2019, Vol. 49 ›› Issue (12): 27-35. doi: 10.12020/j.issn.0253-4312.2019.12.27

Previous Articles Next Articles

Study on the Effect of Laser and Plasma Treatment on the Adhesion of Composite Surface Coating

Tang Peng ^1，2，Wang Yang ^1，2，Cao Dongping ^1，2，Gao Lixin³，Zhou Ganhua³，Zhu Hao³，Liu Xiusheng ^1，2

1. Wuhan Research Institute of Materials Protection Co. ,Ltd.， Wuhan，Hubei 430030，China； 2. State Key Laboratory of Special Surface Protection Materials and Application Technology，Wuhan，Hubei 430030，China；
3. Chery New Energy Automotive Technology Co.， Ltd.， Wuhu，Anhui 241000，China

Received:2019-06-12 Revised:2019-10-18 Online:2019-12-01 Published:2019-12-01
Contact: Liu XiuSheng E-mail:whcbslxs@sina.com

激光和等离子处理对复合材料表面涂层附着力的影响研究

汤朋 ^1，2，汪洋 ^1，2，曹东萍 ^1，2，高立新 ³，周甘华 ³，朱浩 ³，刘秀生 ^*1,2

1.武汉材料保护研究所有限公司，武汉430030； 2.特种表面保护材料及应用技术国家重点实验室，武汉 430030； 3.奇瑞新能源汽车技术有限公司，安徽芜湖 241000

通讯作者: 刘秀生 E-mail:whcbslxs@sina.com
基金资助:
汽车复合材料车身模压成形技术与装备资助

Abstract

Abstract: In order to improve the adhesion of epoxy coatings on fiber reinforced polypropylene composite material，laser and plasma surface treatment methods were used. The effects of laser and plasma surface treatment on surface morphology，surface roughness and contact angle of fiber reinforced polypropylene composite were studied in detail with hyperfield microscope，roughness tester，contact angle tester and adhesion tester . The effects of these two surface treatments on the adhesion of epoxy coatings on composite was also investigated. The results showed that the adhesion of epoxy coatings on the substrates could be significantly improved by both treatments，from less than 1 MPa to higher than 8 MPa.

Key words: laser treatment, plasma treatment, composite, surface roughness, surface morphology, contact angle, adhesion, epoxy coatings

摘要： 为了提高环氧涂料在纤维增强聚丙烯复合材料上的附着力，采用激光和等离子体表面前处理方法，应用超景深显微镜、粗糙度测定仪、接触角测试仪以及附着力测试仪，研究了激光和等离子体表面处理对纤维增强聚丙烯复合材料表面形貌、表面粗糙度和表面水接触角的影响，并且探究了这 2种表面处理方式对环氧涂层在复合材料上附着力的影响。结果表明： 2种处理方式均可明显提高环氧涂层在基材上的附着力，附着力均可由不到 1 MPa提高至 8 MPa以上。

关键词: 激光处理, 等离子体处理, 复合材料, 表面粗糙度, 表面形貌, 接触角, 附着力, 环氧涂料

CLC Number:

TQ639.1

Tang Peng , Wang Yang , Cao Dongping , Gao Lixin, Zhou Ganhua, Zhu Hao, Liu Xiusheng ,. Study on the Effect of Laser and Plasma Treatment on the Adhesion of Composite Surface Coating[J]. Paint & Coatings Industry, 2019, 49(12): 27-35.

汤朋 , 汪洋 , 曹东萍 , 高立新 , 周甘华 , 朱浩 , 刘秀生 ,. 激光和等离子处理对复合材料表面涂层附着力的影响研究[J]. 涂料工业, 2019, 49(12): 27-35.

/ / Recommend / Download Citations

URL: https://www.cn-pci.com/EN/10.12020/j.issn.0253-4312.2019.12.27

https://www.cn-pci.com/EN/Y2019/V49/I12/27

References

[1]占小红，范喜祥，高川云，等.脉冲激光清洗碳纤维增强树脂基复合材料表面研究[J].航空制造技术, 2017, 60(20):38-42
[2]REZAEI F，YUNUS R，IBRAHIM N A，et al.Development of short-carbon-fiber-reinforced polypropylene compositefor car bonnet[J].Journal of Macromolecular Science：Part D-Reviews in Polymer Processing, 2008, 47(4):351-357
[3]YOKOZEKI T，ISHIBASHI M，KOBAYASHI Y，et al.Evaluation of adhesively bonded joint strength of CFRPwith laser treatment[J].Advanced Composite Materials, 2015, 25(4):317-327
[4]OLIVEIRA V，SHARMA S P，DE MOURA M F S F，et al. Surface treatment of CFRP composites using femtosecondlaser radiation[J].[J].Optics and Lasers in Engineering, 2017, 94:37-43
[5]潘祖仁 .高分子化学 [M]. 5版 .北京：化学工业出版社， 2011.
[6]闫霜，尚欣宇，邸明伟.打磨对木粉聚乙烯复合材料射流等离子体表面处理时效性的影响[J].化学与黏合, 2019, 41(1):5-8
[7]董立强，张英辉，胡高全，等.等离子体表面处理技术在橡胶粘合中的应用[J].轮胎工业, 2019, 39(4):0235-0238
[8]王静，孟伶智，任航，等.等离子体处理的时效性对芳 Ⅲ双马复合材料耐湿热性能的影响[J].装备环境工程, 2018, (2):41-44
[9]XIAOGY，LU Y P，XU W H，et al.Microstructure and cytocompatibility of plasma sprayed gradient hydroxyapatite coatings[J].Surface Engineering, 2015, 31(11):860-866
[10]ARPAGAUS C，OBERBOSSEL G，PHILIPP R V R.Plasma treatment of polymer powders -from laboratory research to industrial application[J].Plasma Processes and Polymers, 2018, 15(12):1800133-
[11]YOOZBASHIZADEH M，CHARTOSIAS M，VICTORINO C，et al.Investigation on the effect of process parameters in atmospheric pressure plasma treatment on carbon fiber reinforced polymer surfaces for bonding[J].Materials and Manufacturing Processes, 2019, 34(6):660-669
[12]CORREIA D M，NUNES-PEREIRA J，ALIKIN D，et al. Surface wettability modification of polyand copolymer films and membranes by plasma treatment[J].[J].Polymer, 2019, 169:138-147
[13]任煜，邱夷平.低温等离子体对高聚物材料表面改性处理时效性的研究进展[J].材料导报, 2007, (1):56-59
[14]VOLPE C D，FAMBRI L，FENNER R，et al.Air-plasma treated polyethylene fibres：effect of time and temperature ageing on fibre surface properties and on fibre-matrix adhesion[J].Journal of Materials Science, 1994, 29(15):3919-3925
[15]MAIJU PYK.NEN，SUNDQVIST H，KAUKONIEMI O V,et alAgeing effect in atmospheric plasma activation of paper substrates[J].Surface & Coatings Technology, 2008, 202(16):3777-3786
[16]MORENT R，GEYTER N D，LEYS C，et al.Study of the ageing behaviour of polymer films treated with a dielectric barrier discharge in air，helium and argon at medium pressure[J].Surface & Coatings Technology, 2007, 201(18):7847-7854

Please choose a citation manager

Content to export

Study on the Effect of Laser and Plasma Treatment on the Adhesion of Composite Surface Coating

激光和等离子处理对复合材料表面涂层附着力的影响研究

PDF

Knowledge

Cited

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments

[1]	ZHAO S L, JIANG M, ZHU J Y. One-step Hydrothermal Preparation of Silicate Composite Coating on AZ91D Magnesium Alloys [J]. Paint & Coatings Industry, 2025, 55(9): 69-75.
[2]	FANG J J, WANG Q H, XU K, et al. The Current Situation and Research Progress of Fireproof Coatings in the Oil and Gas Field [J]. Paint & Coatings Industry, 2025, 55(8): 75-82.
[3]	MA Y B, LIU B L, MA Y J, et al. Preparation and Properties of Ultralight Hollow Polymer Microspheres for Thermal Insulation Coatings [J]. Paint & Coatings Industry, 2025, 55(5): 53-59.
[4]	WU B X, YANG F, ZOU L M, et al. Study on the Color Protection Performance of Color High-temperature Resistant Powder Coatings [J]. Paint & Coatings Industry, 2025, 55(4): 27-31.
[5]	CUI C, HAN G M, LIU Q, et al. Preparation and Properties of High Weather Resistance Polyurethane/TiO₂-cement Composite Waterproof Coatings [J]. Paint & Coatings Industry, 2025, 55(4): 54-59.
[6]	WU B X, WANG R F, YAO H, et al. Research and Application of Waterborne Two-component Epoxy Coatings on Substrate with Residual Waterborne Rust Inhibitor [J]. Paint & Coatings Industry, 2025, 55(4): 75-80.
[7]	TANG C, WANG J W, SUX Y, et al. Effect of Composite Fillers on Sound Insulation Performance of Waterborne Epoxy Coatings [J]. Paint & Coatings Industry, 2025, 55(1): 52-57.
[8]	TAO X, CHEN X, ZOU X, et al. Research Progress in Surface Protective Coatings for Fiber Reinforced Composites [J]. Paint & Coatings Industry, 2025, 55(1): 82-88.
[9]	GAO D H, LI S, SONG X R, et al. Preparation and application of smart antibacterial coating composed of acrylates copolymers containing cyclodextrin units [J]. Paint & Coatings Industry, 2024, 54(9): 23-29.
[10]	HE H G, GENG Z H, LUO J. Study on the adhesion performance of polyaspartic polyurea primer for construction machinery [J]. Paint & Coatings Industry, 2024, 54(8): 21-26.
[11]	MA N, ZHANG L D, WANG J, et al. The influence of copper phthalocyanine pigment on the recoat adhesion of Monocoat coatings [J]. Paint & Coatings Industry, 2024, 54(7): 41-46.
[12]	HUANG Y Y, ZHANG Z Q, LI Y, et al. Research progress of liquid-like polymer surfaces [J]. Paint & Coatings Industry, 2024, 54(6): 76-81.
[13]	JIA B, CAO J S, QIAO Y L, et al. The Preparation and Research of Acrylate Latex Based on Polycarbonate Highly Resistant Plastic Paint [J]. Paint & Coatings Industry, 2024, 54(5): 27-31.
[14]	LI Y K, WANG J S, LIU S P, et al. Preparation of Two-component Waterborne Epoxy Coatings with High Thixotropy and High Anti-sagging Resistance [J]. Paint & Coatings Industry, 2024, 54(5): 49-54.
[15]	MA J X, CHEN Y P, LUO J, et al. Effect of Reactive Diluent on Properties of Electron Beam (EB) Cured Pressure Sensitive Adhesives [J]. Paint & Coatings Industry, 2024, 54(4): 1-8.

模态框（Modal）标题

Please choose a citation manager

Content to export

Study on the Effect of Laser and Plasma Treatment on the Adhesion of Composite Surface Coating

激光和等离子处理对复合材料表面涂层附着力的影响研究

PDF

Knowledge

Cited

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments