涂料工业 ›› 2017, Vol. 47 ›› Issue (12): 36-41.

• 健康·安全·环境 • 上一篇    下一篇

高固体分环氧涂料的制备与研究

康瑞瑞,李陈郭,李至秦,杨名亮,苏雅丽,方大庆   

  1. 厦门双瑞船舶涂料有限公司
  • 出版日期:2017-12-01 发布日期:2019-05-31
  • 作者简介:康瑞瑞(1988-),女,工程师,研究方向为防腐涂料。
  • 基金资助:
    国家十二五科技支撑计划项目(2014BAE12B01)

Preparation and Properties of High Solid Epoxy Coatings

Kang Ruirui, Li Chenguo, Li Zhiqin, Yang Mingliang, Su Yali, Fang Daqing   

  1. Xiamen Sunrui Ship Coating Co, Ld, Xiamen, Fujian 361101, China
  • Online:2017-12-01 Published:2019-05-31

摘要: 以自制低黏度二聚酸改性环氧树脂(HEH)、双酚A环氧树脂和低黏度固化剂开发出VOC含量为79.2 g/L的高固体分环氧涂料。采用盐雾试验、3.5%Na Cl溶液和10%Na OH溶液浸泡试验、阴极剥离试验研究了HEH用量、颜料体积浓度(PVC)以及固化剂对涂层防腐性能的影响。采用SEM、EIS和DSC对涂层性能进行了表征。结果表明:HEH与E51按质量比1∶1复配,PVC=0.30且使用脂环胺固化剂时,涂层孔隙率小,致密性好,防腐性能优异。

关键词: 改性环氧树脂, 高固体分涂料, 防腐, VOC

Abstract: A high solid epoxy coating with VOC of 79. 2 g/L was developed by using self-prepared low viscosity epoxy resin( HEH modified by dimer acid, bisphenol A epoxy resin and low viscosity curing agent. The effects of the amount of self-prepared resin, the PVC of coatings and the curing agents on the corrosion resistance of the coating were studied by salt spray test, 3. 5% Nacl (aq)and 10% NAOH (aq) soaking test and cathodic stripping test.The coatings were also characterized by SEM, EIS and DSC. The results showed that when HEH and E51 were blended at with a mass ratio of 1: 1, PVC=0. 30 and the curing agent was alicyclic amine, the cured coating exhibited small porosity, good density and excellent coro-sion resistance.

Key words: modified epoxy, high solid coatings, anticorrosion, VOC.