Paint & Coatings Industry ›› 2024, Vol. 54 ›› Issue (6): 65-70. doi: 10.12020/j.issn.0253-4312.2023-304

• Application & Research • Previous Articles     Next Articles

Study on the effect of ordinary portland cement on drying time and sound insulation efficacy of soundproof coatings

WANG Huaquan,LIU Xiaoli,ZHAO Youqiang,LIU Guangming   

  1. China Resources Cement Technology R&D Co.,Ltd.,Guangzhou 510000,China
  • Online:2024-06-01 Published:2024-06-01

普通硅酸盐水泥对隔声涂料干燥时间和隔声性能影响的研究

王华权,刘晓丽,赵有强,刘广明   

  1. 华润水泥技术研发有限公司,广州 510000
  • 作者简介:王华权(1993—),男,工程师,主要研究方向为功能涂料。

Abstract: In order to shorten the drying time of waterborne soundproof coatings,ordinary Portland cement was added as a filler into the soundproof coatings. The effect of addition amount of ordinary Portland cement on the impact insulation performance of sound insulating coatings was studied by using a simple self-developed impact sound detection device. Through scanning electron microscopy(SEM), the effect of cement on the microstructure of the soundproof coatings was analyzed. The results indicated that the addition of a certain amount of ordinary Portland cement in the soundproof coatings could trigger a hydration reaction,resulting in the formation of products such as hydrated calcium carbonate gel,which could improve the drying efficiency and soundproofing performance of the waterborne soundproof coatings. With the addition of 6% ordinary Portland cement,the drying time of the soundproof coatings could be shortened to less than 48 hours. With the addition of 4% ordinary Portland cement,the impact sound insulation performance of the soundproof coatings was improved by75%. The on-site construction of the soundproof coatings(with 4% ordinary Portland cement addition)completely dried within 48 hours,The standardized impact sound pressure level of the floor slab was 63 dB,which meet the national two-star green building standard. 



Key words: soundproof coatings, ordinary Portland cement, drying time, sound insulation performance

摘要: 为缩短水性隔声涂料的干燥时间,将普通硅酸盐水泥作为填料掺入隔声涂料中,采用自研的简易版撞击声检测装置,探究了普通硅酸盐水泥添加量对隔声涂料撞击隔声性能的影响,并通过扫描电子显微镜( SEM),分析了硅酸盐水泥对隔声涂料微观形貌的影响。结果表明:隔声涂料中加入一定量的硅酸盐水泥,水泥在涂料中发生水化反应,生成水化碳酸钙凝胶等产物,对涂料的干燥效率和隔声性能起到提升作用。硅酸盐水泥添加量达到 6%,隔声涂料的干燥时间可以缩短至 48 h以内;硅酸盐水泥添加量达到 4%,隔声涂料的撞击声隔声性能提升了 75%。隔声涂料( 4%硅酸盐水泥添加量)现场施工, 48 h内完全干燥,楼板计权标准化撞击声压级为 63 dB,达到国家二星级绿色建筑标准。

关键词: 隔声涂料, 硅酸盐水泥, 干燥时间, 隔声性能

CLC Number: