Paint & Coatings Industry ›› 2023, Vol. 53 ›› Issue (7): 27-33. doi: 10.12020/j.issn.0253-4312.2022-348

Previous Articles     Next Articles

Preparation and Properties of Aqueous Fluorinated Hydroxylic Acrylic Resin Secondary Dispersion

Mo Wangqi1,Feng Dechen1,Liu Wenhao1,Shu Jinbing1,2,Shen Liang1,2   

  1. 1. The Department of Coatings and Polymeric Materials,College of Chemistry and Chemical Engineering,Jiangxi Science & Technology Normal University,Nanchang 330013,China; 2. Jiangxi Provincial Engineering Research Center for Waterborne Coatings,Nanchang 330013,China
  • Online:2023-07-01 Published:2023-07-01

水性含氟羟基丙烯酸二级分散体的制备及性能研究

莫旺奇1,冯德臣1,刘文浩1,舒金兵*1,2,申亮1,2   

  1. 1. 江西科技师范大学化学化工学院涂料与高分子系,南昌330013;
    2. 江西省水性涂料工程研究中心,南昌330013

Abstract: In this paper,through the two-step polymerization process,fluorinated acrylicacid monomer was added into the synthesis of conventional hydroxyl acrylic acid resindispersion,the high gloss and high endurance aqueous fluorinated hydroxyl acrylic acidsecondary dispersion(FHAD)was successfully prepared. The effects of the type and content offluorinated acrylic acid monomer on the properties of FHAD were investigated. The experimental results showed that when hexafluorobutyl methacrylate(HFBMA)was added and the content was 8%,the dispersion owned small particle size,moderate viscosity and excellent heat storage stability. Meanwhile,the two-component coatings prepared with the dispersionand water-based isocyanate curing agent AQUAPU-298 owned the excellent gloss. The glossof 20°,60° and 85° was 83. 6,93. 9 and 99. 5 respectively. What’s more,the acid and alkali  resistance of films had been greatly improved and the water resistance(25 ℃)could achieve 312 hours,significantly improved the endurance of conventional acrylic dispersion.


Key words: hydroxylic acrylic resin dispersion, fluorinate acryic acid, gloss, water resistance

摘要: 通过两层法聚合工艺,将含氟丙烯酸单体引入常规羟基丙烯酸分散体树脂的合成中,制备出高光泽、高耐性的水性含氟羟基丙烯酸二级分散体( FHAD)。研究了含氟丙烯酸单体种类及用量对 FHAD性能的影响,结果表明:当添加 8%甲基丙烯酸六氟丁酯( HFBMA)时,制得的分散体粒径小、黏度适中且热贮存稳定性优异。将该分散体与水性异氰酸酯固化剂 AQUAPU-298搭配制备水性双组分聚氨酯涂料,固化后的漆膜具有优异的光泽, 20°、60°、85°光泽分别为 83. 6、93. 9、99. 5;同时耐水性、耐酸、耐碱性也显著提高,有效改善了常规丙烯酸二级分散体的性能。

关键词: 羟基丙烯酸分散体, 含氟丙烯酸, 光泽, 耐水性

CLC Number: